Jeep Cherokee KJ 2002-2007

Suitable for the following vehicle type:Manufacturer: Daimler Chrysler (USA)Type: KJDescription: Jeep CherokeeYear of manufacture: 2001-2008ETG-No.: e4*2001/116*0128*...The offered daytime running light + fog light is a vehicle specific item. The daytime running light fits into the original cutouts of the fog lights. The mounting is done on the existing mounting points on the bumper.Our 2in1 daytime running lights are designed for vehicles with stock fog lights. If your vehicle does not have original fog lights, then you need not only a corresponding trim with cutout in the front for the fog lights but also a daytime running light set with a separate on and off switch for the fog lights.Please select the appropriate set in our store!The daytime running lights are delivered with a H11 plug (the picture above shows a HB4 plug). This plug is suitable for some vehicles (such as partially VW, Audi, Seat, etc....). If this is not suitable for your model, our H11 plug must be replaced by a vehicle-specific plug. This is unfortunately not offered by us. You also have the option to disconnect the connectors and connect the cables.Vehicles with Can-Bus-System!The vehicles of the newer generation are nowadays equipped with so-called Can-Bus or LIN-Bus systems, which check the light, display and turn signal function by means of a low, permanent test current. So that after the installation of our daytime running lights+fog lights and the omission of the standard fog lights no error message is displayed, we can supply together with the lights a load resistor, which is connected to the connection cables of the fog lights. So you can install the set on your vehicle without any error. Please notify us after your purchase if your vehicle is equipped with a CanBus system.Approval Regulations:Europe-wide approval thanks to ECE, E11, R87 and RL designation.Thanks to the E- and F-approval marks on the lens, the article is 100% road legal andapproved in road traffic and registration-free.The daytime running lights do not have to be entered in the vehicle documents.Thanks to the test marks on the diffusing lens of the daytime running lights, no documents (such as test reports, ABE, etc.) need to be carried with the vehicle documents.We have been offering off road accessories with service and company headquarters in Germany for 40 years. Ask us to learn more about our items. We will be happy to help you.

The offered daytime running light is a vehicle-specific article, specifically for the suitable for Jeep Cherokee KJ (2001-2008).The daytime running light fits into the original cutouts of the fog light cover. It mounts to the existing mounting points with a vehicle specific mounting adapter in the bumper. If your vehicle does not have standard fog lights, you can purchase such a cover with appropriate recesses inexpensively from your vehicle dealer or on the Internet.Important:The lights cannot be used as cornering lights (function is omitted on your vehicle, if available) The daytime running lights are replaced with the factory-fitted fog lights. The fog function is omitted. The daytime running lights are supplied with dimming function.Details:Set of 2 daytime running lights (right + left) with very powerful white LED.The control unit of the LED is already built inextremely durable LED with very high luminosity / bright white signal light - not comparable with the light of the original fog lightseasy installation thanks to special vehicle-specific bracketswaterproof robust plastic housingdaytime running light dims down by 50% when the low beam is switched onno measurable additional power consumption compared to driving without lightspower consumption: 12 Volt = 3,4 WSTVO / TÜV approval (100% registration free!)Since 40 years we offer off road accessories with service and headquarter in Germany. Ask us to learn more about our articles. We will be happy to help you.

The spinners bring real racing design to the look of your vehicle - quickly and absolutely individually.The spinners (3-star center caps) are invisibly screwed to the hub cover of the rim. Quickly mounted - cool look. When mounting, make sure that the spinners do not protrude beyond the rim or vehicle width.Dimensions:Height 3cmDiameter 14cmDiameter without wings 8cmScope of delivery:1x Spinner (please buy the desired quantity!)Material spinner: chrome-plated metal / middle cover plastic blackMounting material (screw + nut)Important!The pictured cover plate of the rim is not included but should already be present on your rim.The hub covers are not approved according to StVZO, even if they do not extend beyond the rim.Note on mounting: The spinners are screwed to the hub cap / hub cover. For this purpose, a hole must be drilled in the hub cap. The spinner is then placed on the hub cap and the bolt is passed through and fastened from behind with the nut. Finally, the black cap is placed on top and nothing can be seen of the screw connection.For 40 years we offer off road accessories with service and company headquarters in Germany. Ask us to learn more about our items. We will be happy to help you.

The offered daytime running light is a vehicle specific item, specifically for the Jeep Cherokee KJ (2001-2008). The daytime running light fits into the original cutouts of the fog light cover. It mounts to the existing mounting points with a vehicle specific mounting adapter in the bumper. If your vehicle does not have standard fog lights, you can purchase such a cover with appropriate recesses inexpensively from your vehicle dealer or on the Internet.Important:The lights cannot be used as cornering lights (function not applicable to your vehicle, if available). The daytime running lights are replaced with the factory-fitted fog lights. The fog function is omitted. The daytime running lights are supplied without dimming function.Details:Set of 2 daytime running lights (right + left) with very powerful white LED.The control unit of the LED is already built inextremely durable LED with very high luminosity / bright white signal light - not comparable with the light of the original fog lightseasy installation thanks to special vehicle-specific bracketswaterproof robust plastic housingthe daytime running light switches off automatically when the low beam is switched onno measurable additional power consumption compared to driving without lightspower consumption: 12 Volt = 3,4 WSTVO / TÜV approval (100 % registration free!)Since 40 years we offer off road accessories with service and headquarter in Germany. Ask us to learn more about our articles. We will be happy to help you.

Extremely flat light with white lens. Very popular with US pickup drivers as a position light. But also ideal for trucks, motorhomes, vans etc. Splash-proof version. Without E-mark!The luminaire is supplied with a 12 volt plug-in bulb with a glass base. If you have a 24 volt connection, you must replace this with 24 volt. This bulb is not offered by us, but can be bought in any DIY store.

Please be sure to compare our product with the fan heaters from other suppliers!At first glance, these look similar - but they are not! The price difference is made by the following important detail:Our 300 watt fan heater must be connected directly to the battery or fuse box. This is the only way to ensure the required power consumption.If connected via the cigarette lighter, the power cables of the cigarette lighter would become too hot and major damage, including fire, could occur.A connection via the cigarette lighter is only recommended up to a maximum of 120 watts. Fan heaters that are connected via the cigarette lighter, usually do not perform more than between 80 - 120 watts. This is just enough to generate a "warm breeze".Please compare first and then buy!Details:-Width 140 mm x depth 175 mm x height 110 mm incl. foot.-output temperature fan heater: approx. 50° degrees-Cable length: approx. 2.5 mtr.-Cable with integrated plug fuse 30 A and plug connector for direct connection to the battery-360° rotating base (adjustable in lateral orientation as well as inclination)-heating and separate fan function-Material inside: Polyamide 66 CF20 (high dimensional stability)-Onboard voltage: 12 volts-Nominal power at 12.8 volts (charged battery) approx. 18.5 amps (240 watts)-Peak power at 13.8 volts (running engine or new battery)approx. 22 amps (300 watts)Quick assembly / disassembly of the fan heater is done with Velcro tape (see picture above), alternatively the base can be screwed. Easy mounting of the fan heater on the adjustable stand (see picture above). The cable can be laid through the interior to the engine compartment, depending on the possibility.Through the connector plug, the fan can be easily removed at any time.The connection is then made directly to the fuse box or the battery (see pictures above).Several switch functions are available for selection:1. switch top = only fan / blower.2. switch down = heating with half fan power3. both switches = heating with full power / full blowerFan heater usage note: The fan heater should always be operated in a dry and heat-resistant location, only under supervision and away from children's hands. Care should be taken to keep the fan heater away from highly flammable materials. Do not block the ventilation flaps.  We have been offering off road accessories for 40 years with service and headquarters in Germany. Ask us to learn more about our items. We will be happy to help you.

Ceramic fan heater, ideal for cars, off-road vehicles, vans, campers, buses and trucks with 12 volt on-board voltage. This is individually adjustable in the inclination, it can be decided on the basis of 2 switching levels between heating and cooling. Through the rotary switch, the fan can be regulated in different stages.The connection is only possible directly to the battery.NO connection via the cigarette lighter!Please be sure to compare our product with the fan heaters from other suppliers!At first glance, these look similar - but they are not! The price difference is made by the following important detail: Our 400 Watt fan heater must be connected directly to the battery or the fuse box. This is the only way to ensure the required power consumption.If connected via the cigarette lighter, the power cables of the cigarette lighter would become too hot and major damage, including fire, could occur.A connection via the cigarette lighter is only recommended up to a maximum of 120 watts. Fan heaters that are connected via the cigarette lighter, usually perform no more than between 80 - 120 watts. This is just enough to generate a "warm breeze".Please compare first and then buy!Details:- 400 watts-12 volts-current consumption: approx. 26-30 amp-Width 185 x depth 115 x height 140mm-output temperature fan heater: 50° degrees-Cable length: approx. 3m-Cable with integrated fuse 30A and ring tongue plug for connection to batteryThe fan heater should always be operated in a dry and heat-resistant location, only under supervision and away from children's hands. Care should be taken to keep the fan heater away from easily flammable materials. Do not block the ventilation flaps. We have been offering off road accessories for 40 years with service and headquarters in Germany. Ask us to learn more about our items. We will be happy to help you.

Ceramic fan heater, ideal for cars, off-road vehicles, vans, campers, buses and trucks with 12 volt on-board voltage. This is individually adjustable in the inclination, it can be decided on the basis of 2 switching levels between heating and cooling. Through the rotary switch, the fan can be regulated in different stages.The connection is only possible directly to the battery.NO connection via the cigarette lighter!Please be sure to compare our product with the fan heaters from other suppliers!At first glance, these look similar - but they are not! The price difference is made by the following important detail:Our 300 watt fan heater must be connected directly to the battery or fuse box. This is the only way to ensure the required power consumption. If connected via the cigarette lighter, the power cables of the cigarette lighter would become too hot and major damage, including fire, could occur. A connection via the cigarette lighter is only recommended up to a maximum of 120 watts. Fan heaters that are connected via the cigarette lighter, usually do not perform more than between 80 - 120 watts. This is just enough to generate a "warm breeze".Please compare first and then buy!Details:-300 watts-12 volts-current consumption: approx. 24-27 amp-Width 185 x depth 115 x height 140mm-output temperature fan heater: 50° degrees-Cable length: approx. 3m-Cable with integrated fuse 30A and ring tongue plug for connection to batteryThe fan heater should always be operated in a dry and heat-resistant location, only under supervision and away from children's hands. Care should be taken to keep the fan heater away from easily flammable materials. Do not block the ventilation flaps. We have been offering off road accessories for 40 years with service and headquarters in Germany. Ask us to learn more about our items. We will be happy to help you.

Universal fitting lamp bracket made of stainless steel, highly polished for roof mounting. Brackets for 4 headlights are already present on the lamp bracket (headlights must be ordered separately). Internal cable routing. Suitable for all headlight sizes, except item number 1811! Dimensions :Width: 120 cmDepth : 26 cmDiameter of the tubes: 32 mmThe pictured headlights must be ordered separately, please see our store. The lamp bracket is delivered without TÜV certificate.For 40 years we offer off road accessories with service and company headquarters in Germany. Ask us to learn more about our articles. We are happy to help you.

Universal fitting lamp bracket made of stainless steel, highly polished for roof mounting. Brackets for 4 headlights are already present on the lamp bracket (headlights must be ordered separately). Internal cable routing. Suitable for headlights up to a diameter of 17cm.Dimensions :Width 96cmDepth about 27cmDiameter of the tubes 26mm The pictured headlights must be ordered separately, please see our store. The lamp bracket is delivered without TÜV certificate.For 40 years we offer off road accessories with service and company headquarters in Germany. Ask us to learn more about our items. We will be happy to help you.

Off-road spade made entirely of stainless steel. Spade with holder suitable for all spare wheel holders at the rear. The theft-proof bracket can be universally adapted to any vehicle and any tyre.We have been offering off-road accessories for 40 years with service and company headquarters in Germany. Ask us to find out more about our articles. We will be happy to help you.

Give your vehicle a wider, more stable track - quickly and easily. Wheel spacers are the ideal addition if the standard or accessory wheel lacks the final visual kick. With the right Hofmann wheel spacers, your vehicle gets an even sportier look because the wheels and tyres really fill out the wheel arches this way. The precise adjustment of the track width not only improves the appearance of your vehicle, but also optimises the handling and the rolling tendency.Please understand that we only take back new and uninstalled goods.Suitable for the following vehicle type:Manufacturer: Daimler Chrysler (USA)Type: KJDescription: Jeep CherokeeYear of manufacture: 2001-2008ETG-No.: e4*98/14*0058*...The following tyre sizes are approved according to the TÜV parts certificate,but please observe the respective conditions and notes on tyre sizes:Rim 7x16 with tyres 235/70R16Specifications for wheel spacers:Disc : 23mm thick (widening 46mm per axle)Surface : Aluminium untreatedBolt circle : 5x114,3mmOuter diameter : 150mmInner diameter : 71,6mmWe have been offering off road accessories for 40 years with service and headquarters in Germany. Ask us to find out more about our items. We will be happy to help you.