Nissan Interstar

This headlight bracket is not only a visual eye-catcher, but also serves in conjunction with auxiliary headlights (headlights shown are not included) active safety on the road. Universal fitting lamp bracket for mounting on the roof of the truck. We have also attached a sketch with the dimensions of the headlight bracket. Please check the dimensions to see if the headlight bracket will fit on your truck.We have been providing off road accessories for 40 years with service and headquarters in Germany. Ask us to learn more about our items. We will be happy to help you.

For the connection of e.g. daytime running lights with fog lights you also need these resistors. Our headlights are connected only on one side with the standard fog light line, the right connection side is not needed, this results in an error message displayed in your on-board computer or display. By connecting these special resistors you can mount the daytime running lights error-free on your vehicle.Suitable for vehicles with Can-Bus system!The vehicles of the newer generation are nowadays equipped with so-called Can-Bus or LIN-Bus systems, which check the light, display and turn signal function by means of a low, permanent test current. So that the installation of our daytime running lights and the omission of the standard fog lights no error message is displayed, we offer these resistors for our daytime running lights.Scope of delivery:1x resistor 55 watts / 6 ohms with a H11 plug1x resistor 50 Watt / 6 Ohm with two H11 plugsSuitable for vehicles with Can-Bus system!Cable length: 0,5mwith one waterproof 2-pin plug (H11)We have been offering off road accessories for 40 years with service and headquarters in Germany. Ask us to learn more about our items. We will be glad to help you.

Extremely flat light with orange lens. Very popular with US pickup drivers as a position light. But also ideal for trucks, motorhomes, vans etc. Splash-proof version. Without E-mark!The luminaire is supplied with a 12 volt plug-in bulb with a glass base. If you have a 24 volt connection, you must replace this with 24 volt. This bulb is not offered by us, but can be bought in any DIY store.

Cool styling for the interior of your truck, camper, off-road vehicle, van or car. The illuminated fingers are supplied with a 24-volt bulb, but you can also replace this bulb with a 12-volt bulb so that you can also use the illuminated fingers with 12 volts. The illuminated finger lights up on both sides, one side red and the other side orange. A chrome ring is attached on the outside for decoration.

Cool styling for the interior of your truck, camper, off-road vehicle, van or car. The illuminated fingers are supplied with a 24-volt bulb, but you can also replace this bulb with a 12-volt bulb so that you can also use the illuminated fingers with 12 volts. The illuminated finger lights up on both sides, one side red and the other side orange. A chrome ring is attached on the outside for decoration.

Extremely flat light with white lens. Very popular with US pickup drivers as a position light. But also ideal for trucks, motorhomes, vans etc. Splash-proof version. Without E-mark!The luminaire is supplied with a 12 volt plug-in bulb with a glass base. If you have a 24 volt connection, you must replace this with 24 volt. This bulb is not offered by us, but can be bought in any DIY store.

Please be sure to compare our product with the fan heaters from other suppliers!At first glance, these look similar - but they are not! The price difference is made by the following important detail:Our 300 watt fan heater must be connected directly to the battery or fuse box. This is the only way to ensure the required power consumption.If connected via the cigarette lighter, the power cables of the cigarette lighter would become too hot and major damage, including fire, could occur.A connection via the cigarette lighter is only recommended up to a maximum of 120 watts. Fan heaters that are connected via the cigarette lighter, usually do not perform more than between 80 - 120 watts. This is just enough to generate a "warm breeze".Please compare first and then buy!Details:-Width 140 mm x depth 175 mm x height 110 mm incl. foot.-output temperature fan heater: approx. 50° degrees-Cable length: approx. 2.5 mtr.-Cable with integrated plug fuse 30 A and plug connector for direct connection to the battery-360° rotating base (adjustable in lateral orientation as well as inclination)-heating and separate fan function-Material inside: Polyamide 66 CF20 (high dimensional stability)-Onboard voltage: 12 volts-Nominal power at 12.8 volts (charged battery) approx. 18.5 amps (240 watts)-Peak power at 13.8 volts (running engine or new battery)approx. 22 amps (300 watts)Quick assembly / disassembly of the fan heater is done with Velcro tape (see picture above), alternatively the base can be screwed. Easy mounting of the fan heater on the adjustable stand (see picture above). The cable can be laid through the interior to the engine compartment, depending on the possibility.Through the connector plug, the fan can be easily removed at any time.The connection is then made directly to the fuse box or the battery (see pictures above).Several switch functions are available for selection:1. switch top = only fan / blower.2. switch down = heating with half fan power3. both switches = heating with full power / full blowerFan heater usage note: The fan heater should always be operated in a dry and heat-resistant location, only under supervision and away from children's hands. Care should be taken to keep the fan heater away from highly flammable materials. Do not block the ventilation flaps.  We have been offering off road accessories for 40 years with service and headquarters in Germany. Ask us to learn more about our items. We will be happy to help you.

Ceramic fan heater, ideal for cars, off-road vehicles, vans, campers, buses and trucks with 24 volt on-board voltage. This is individually adjustable in the inclination, it can be decided on the basis of 2 switching levels between heating and cooling. Through the rotary switch, the fan can be regulated in different stages.The connection is only possible directly to the battery.NO connection via the cigarette lighter!Please be sure to compare our product with the fan heaters from other suppliers!At first glance, these look similar - but they are not! The price difference is made by the following important detail: Our 400 Watt fan heater must be connected directly to the battery or the fuse box. This is the only way to ensure the required power consumption. If connected via the cigarette lighter, the power cables of the cigarette lighter would become too hot and major damage, including fire, could occur. A connection via the cigarette lighter is only recommended up to a maximum of 120 watts. Fan heaters that are connected via the cigarette lighter, usually perform no more than between 80 - 120 watts. This is just enough to generate a "warm breeze".Please compare first and then buy!Details:- 400 watts- 24 volts-current consumption: approx. 25-27 amp-Width 185 x depth 115 x height 140mm-output temperature fan heater: 50° degrees-Cable length: approx. 3m-Cable with integrated fuse 30A and ring tongue plug for connection to batteryThe fan heater should always be operated in a dry and heat-resistant location, only under supervision and away from children's hands. Care should be taken to keep the fan heater away from easily flammable materials. Do not block the ventilation flaps. We have been offering off road accessories for 40 years with service and headquarters in Germany. Ask us to learn more about our items. We will be happy to help you.

Ceramic fan heater, ideal for cars, off-road vehicles, vans, campers, buses and trucks with 12 volt on-board voltage. This is individually adjustable in the inclination, it can be decided on the basis of 2 switching levels between heating and cooling. Through the rotary switch, the fan can be regulated in different stages.The connection is only possible directly to the battery.NO connection via the cigarette lighter!Please be sure to compare our product with the fan heaters from other suppliers!At first glance, these look similar - but they are not! The price difference is made by the following important detail: Our 400 Watt fan heater must be connected directly to the battery or the fuse box. This is the only way to ensure the required power consumption.If connected via the cigarette lighter, the power cables of the cigarette lighter would become too hot and major damage, including fire, could occur.A connection via the cigarette lighter is only recommended up to a maximum of 120 watts. Fan heaters that are connected via the cigarette lighter, usually perform no more than between 80 - 120 watts. This is just enough to generate a "warm breeze".Please compare first and then buy!Details:- 400 watts-12 volts-current consumption: approx. 26-30 amp-Width 185 x depth 115 x height 140mm-output temperature fan heater: 50° degrees-Cable length: approx. 3m-Cable with integrated fuse 30A and ring tongue plug for connection to batteryThe fan heater should always be operated in a dry and heat-resistant location, only under supervision and away from children's hands. Care should be taken to keep the fan heater away from easily flammable materials. Do not block the ventilation flaps. We have been offering off road accessories for 40 years with service and headquarters in Germany. Ask us to learn more about our items. We will be happy to help you.

Ceramic fan heater, ideal for cars, off-road vehicles, vans, campers, buses and trucks with 24 volt on-board voltage. This is individually adjustable in the inclination, it can be decided on the basis of 2 switching levels between heating and cooling. Through the rotary switch, the fan can be regulated in different stages.The connection is only possible directly to the battery.NO connection via the cigarette lighter!Please be sure to compare our product with the fan heaters from other suppliers!At first glance, these look similar - but they are not! The price difference is made by the following important detail:Our 300 watt fan heater must be connected directly to the battery or fuse box. This is the only way to ensure the required power consumption.If connected via the cigarette lighter, the power cables of the cigarette lighter would become too hot and major damage, including fire, could occur.A connection via the cigarette lighter is only recommended up to a maximum of 120 watts. Fan heaters that are connected via the cigarette lighter, usually do not perform more than between 80 - 120 watts. This is just enough to generate a "warm breeze".Please compare first and then buy!Details:-300 watts- 24 volts-current consumption: approx. 25-27 amp-Width 185 x depth 115 x height 140mm-output temperature fan heater: 50° degrees-Cable length: approx. 3m-Cable with integrated fuse 30A and ring tongue plug for connection to batteryThe fan heater should always be operated in a dry and heat-resistant location, only under supervision and away from children's hands. Care should be taken to keep the fan heater away from easily flammable materials. Do not block the ventilation flaps. We have been offering off road accessories for 40 years with service and headquarters in Germany. Ask us to learn more about our items. We will be happy to help you.

Ceramic fan heater, ideal for cars, off-road vehicles, vans, campers, buses and trucks with 12 volt on-board voltage. This is individually adjustable in the inclination, it can be decided on the basis of 2 switching levels between heating and cooling. Through the rotary switch, the fan can be regulated in different stages.The connection is only possible directly to the battery.NO connection via the cigarette lighter!Please be sure to compare our product with the fan heaters from other suppliers!At first glance, these look similar - but they are not! The price difference is made by the following important detail:Our 300 watt fan heater must be connected directly to the battery or fuse box. This is the only way to ensure the required power consumption. If connected via the cigarette lighter, the power cables of the cigarette lighter would become too hot and major damage, including fire, could occur. A connection via the cigarette lighter is only recommended up to a maximum of 120 watts. Fan heaters that are connected via the cigarette lighter, usually do not perform more than between 80 - 120 watts. This is just enough to generate a "warm breeze".Please compare first and then buy!Details:-300 watts-12 volts-current consumption: approx. 24-27 amp-Width 185 x depth 115 x height 140mm-output temperature fan heater: 50° degrees-Cable length: approx. 3m-Cable with integrated fuse 30A and ring tongue plug for connection to batteryThe fan heater should always be operated in a dry and heat-resistant location, only under supervision and away from children's hands. Care should be taken to keep the fan heater away from easily flammable materials. Do not block the ventilation flaps. We have been offering off road accessories for 40 years with service and headquarters in Germany. Ask us to learn more about our items. We will be happy to help you.

Spare part: suitable for our 15", 16" and 22.5" wheel trims.Scope of delivery:5x spacer, small 5x mounting screwFor 40 years we have been offering truck and off-road accessories with service and company headquarters in Germany. Ask us to find out more about our articles. We will be happy to help you.